WELCOME!

It is hard to believe that it was almost ten years ago I witnessed a CNC router in action for the very first time. I was fascinated and simply had to have one! Although I had been in the creative end of the three dimensional sign business for most of my life I didn't really know what I would do with one of these machines - but I just knew it could do fantastic stuff.

Along with the CNC router I discovered the wonderful material called Precision Board and the glues, primers and other companion products they offer. Since then we have gone through many tons of the material using it in most signs and projects we tackle. This journal will chronicle our many adventures both past, present and future. I'll talk from the perspective of someone who pushes these products to the creative limit on a daily basis. I'll be adding to the stories two or three times each week. -dan

Tuesday, January 27, 2015

Lectern - Part four

I've long believed that if we come up with better ideas as we are building something the plan needs to be adjusted. Sometimes it means a little more time or materials but the whole idea of doing this kind of work is to do the very best we can possibly do.

After the weekend off I came back into the shop to work on the lectern.  I assembled the base and set the stand back on. As I did some finishing and fitted the gears I decided they were just too far apart from the base. After looking things over I decided the gears that theoretically adjust the tilt of the table needed to be part of the brackets rather than stand alongside. The solution required parking the gears and then cutting them to fit around the brackets. A little sculpting epoxy blended the seams together nicely.



There is still some small bits to route and assemble but it won't be long until it is time for paint.