WELCOME!

It is hard to believe that it was almost ten years ago I witnessed a CNC router in action for the very first time. I was fascinated and simply had to have one! Although I had been in the creative end of the three dimensional sign business for most of my life I didn't really know what I would do with one of these machines - but I just knew it could do fantastic stuff.

Along with the CNC router I discovered the wonderful material called Precision Board and the glues, primers and other companion products they offer. Since then we have gone through many tons of the material using it in most signs and projects we tackle. This journal will chronicle our many adventures both past, present and future. I'll talk from the perspective of someone who pushes these products to the creative limit on a daily basis. I'll be adding to the stories two or three times each week. -dan

Saturday, February 16, 2013

Building a train - Part fifteen


The last step of amy project is to ready it for shipping. In this case we get to have the fun of delivering it ourselves. The train weighed in at 1,664 lbs. I had built a sturdy lift point into the roof of the cab on the steam engine. It was a simple matter of threading through a small chain and then using the forklift to haul it over to the trailer.


In only a couple of days out in the weather the rust evened out nicely, making the train look like it was a hundred years old. This is going to look fabulous high on the trestle when it is installed at the adventure golf.




I'll be making the delivery in less than a week. These trips are always fun with lots of stares and waves as we travel down the road... this time more than a hundred miles distant. I'll take a few more shots as we travel and on arrival. Stay tuned...

-dan